I'm doing a build on a DMG CPU revision 08 where I wish to use a BennVenn RGB backlight controller to set the color of an RGB backlight from Kitsch Bent along with an RGB button kit from Thursday Customs.
Alternative link here, if I can't get images to show:
My question is about the connections from the RGB controller pcb to the ribbon cable pins on the cable connector on the DMG CPU pcb. BennVenn shows a picture of this install on his Fb page, but all the wires he's using are red (me nub not savvy) and I can simply not get the things to connect between the the numbering (10-15) on his pcb and the the ribbon cable pin numbers on the schematics for the DMG.
I've marked the pins BennVenn is using in red on the image and labelled them from "a" to "f". The two pins marked in yellow are for the bivert mod (for reference).
BennVenn has always been very generous with his time answering questions, but he's doing valuable (and timeconsuming, no doubt!) work, so I thought to reach out to the community for this one.
Anyone can help? And thanks!!
Last edited by irony7 (April 16, 2017 1:21 pm)