Offline
(ノ◕ヮ◕)ノ*:・゚✧ el ass dee j

Hey all!

So I'm about to do a mod that I've been planning for a while, though Thursday Customs doesn't seem to have RGB LED's in stock for buttons.

I was wondering if anybody has had any luck finding a way to add RGB LED's without the above mentioned method, and how you'd go about executing it. I'd imagine it would only take finding ground and pos/neg points on the front board.

Any input would be greatly appreciated.

Thanks!
-Sam

Offline
Alabama

It is actually that simple. Calculate what all you can run off of 5V, wire it up in the case. Add a resistor if the math calls for it. 5V on one side, ground on the other.

Offline
(ノ◕ヮ◕)ノ*:・゚✧ el ass dee j
MaxDolensky wrote:

It is actually that simple. Calculate what all you can run off of 5V, wire it up in the case. Add a resistor if the math calls for it. 5V on one side, ground on the other.

Gotcha. Also found a nice pinout:
https://cdn.shopify.com/s/files/1/0689/ … 1455042687