<![CDATA[ChipMusic.org - Arduinoboy question / what sorts of arduinos work?]]>2012-03-28T23:25:02ZPunBBhttps://chipmusic.org/forums/topic/6518/arduinoboy-question-what-sorts-of-arduinos-work/<![CDATA[Re: Arduinoboy question / what sorts of arduinos work?]]>well supplying power to it, your fine. i think the on board regulator can handle up to 12v. im not too sure about the 8MHz crystal though, i dont think theres any conflict with that.. but im not sure. the optocoupler is powerd by pin 4 i believe. and the LED's... what i suggest you do is put the blink code on there, but make the durration pretty long to test it. get a multimeter and see how many volts pop out of pin 13. then, use this http://led.linear1.org/1led.wiz to figure out resistance. might want to do that to pin 4 also. hope i helped..]]>https://chipmusic.org/Alley+Beach2012-03-28T23:25:02Zhttps://chipmusic.org/forums/post/96914/#p96914<![CDATA[Arduinoboy question / what sorts of arduinos work?]]>I'm about to start building an arduinoboy, and I was wondering if anyone has ever built one with something other than the nano or the uno?
I was wondering if specifically the Fio was a possibility?
The issue I see with it is that it only has a 3.3 volt output, which I didn't know if that would make it usable even if the resistors were changed?