**** NOTICE: IF INFO IS USED FOR PROFIT I WILL HUNT YOU DOWN****
Basically the how to is on my website, but here are the images of how to do it..
there are two circle indents on the inside of the gameboy colors back panel. i made my center punch for the hole at the bottom edge of this circle. Tightening the RCA jack nuts are a little tricky and i recommend using two needle nose pliers for that.
Be sure to deactivate the internal speaker as per my instructions on the "GB Color Line Output Mod" on my website. you can even remove the internal speaker after you remove the normalling resistor. it will give you more room for wire.
Note: I jumper the ground from one rca jack to the other... then ran all the wires under the pcb. this can be done with out removing the pcb. just be careful not to pinch any of the wires..
I used 24Gage wire.. i recommend it..
*click images for more detail*
