Offline
nova scotia

I'm doing a backlight/bivert mod and I've run into some trouble. I've lost all shades of grey. Light grey is appearing as white, and dark grey is appearing as black. Other than that, the bivert seems to be working ok. I've checked for crossed wires and continuity with a multimeter and everything looks like it should be fine. However, it's just acting like the bit 0 wire isn't connected at all. In fact, the screen looks exactly the same whether I have that wire connected or not. I tried resoldering to rule out a bad connection but everything appears to be fine. Any tips on this?

Offline
South UK

Maybe the inverter chip is dodgy? Try using one of the other inverter pairs on the chip and see if that makes a difference

Offline
nova scotia

Figured it out. The chip wasn't at fault, it was where I had placed the cut on the board. Turns out I put it too high (above the little solder point) so I had to bridge the connection and cut lower. Working great now! Pics just for fun.

Offline

Looks great