Hello friends. I have trouble with my arduinoboy. I soldered 1 piece and when I turn it on it always change mode. Leds changed and I don't understand what is going on. I solder this kit https://www.dropbox.com/s/gjk89h42zmusw … s.pdf?dl=0
Button contacts not connected I checked. May be something soldered togeather, but don't understand what.
And one strange thing: I cheked 2 k'ohm resitor (button resistor), when it soldered in the device tester show 1.06 k.om
Offline
Russia
Offline
Michigan
Try a 4.7k to 10k resistor.
Last edited by Jazzmarazz (Jun 22, 2015 11:40 pm)
Offline
Russia
My switch is NO. I mean that buton not soldered, I pull out it, and there are no contact between PB1 and PB2.
10k to the 4.7k place? strange but I'll try.
Offline
Michigan
stress_tn wrote:
My switch is NO. I mean that buton not soldered, I pull out it, and there are no contact between PB1 and PB2.
10k to the 4.7k place? strange but I'll try.
No, use a resistor between 4.7k and 10k instead of the 2k ohm resistor.
Offline
Russia
No, resistor between 4.7k and 10k not help!(
Last edited by stress_tn (Jun 24, 2015 7:55 pm)
Offline
Mexico
I builded the same arduinoboy kit, I just followed the video instructions and it worked https://www.youtube.com/watch?v=13adGnZoC9E Sorry for my bad English
Offline
Toronto, Ontario, Canada
Use a multimeter and make sure nothing is bridging those pins/pads.
Offline
I can't see a resistor on that schematic that goes from the button to ground... It is on the original one tho. You need one or else pin 5 will think it's still connected.
Offline
Brussels, Belgium
Hello,
I don't know if i should make a new thread or reuse this one. I also have trouble making an arduinoboy. Actually, everything seems to work, but neither LSDJ nor mGB seem to receive data.
I've made a little video of my current setup:
https://www.youtube.com/watch?v=vxaYVNTi5wQ